Lighting and Hold-to-Run Controls for Abrasive Blasting

Reviewed by the Daly Middle East technical team — application engineers specialising in ATEX/IECEx hazardous-area lighting and instrumentation.

A blast operator needs to see the nozzle’s working area while managing a hose and wearing protective equipment. Walk through positioning and movement with the operator before equipment is set down. The useful view is what the operator can see through the visor from the working position.

Review the operator control with the equipment owner

Release of a properly designed hold-to-run control should cause the blasting operation to stop as specified by its system. Have the responsible team confirm the control arrangement and test it under the approved procedure. Include those checks in the changeover if the blasting equipment or control system is replaced.

Light the work and the access route

Review where dust or shadows will impair the view, and determine whether fixed area light or a portable unit best supports the task. Check the placement of lighting and leads against hose movement and the area assessment. If the surroundings are classified, ensure the lighting system and connections are suitable for their specific locations and conditions.

Daly lists temporary shutdown lighting and SA Equip work-area lighting for assessment. For the US regulatory example on the operator control, see OSHA guidance on abrasive blast-cleaning nozzles.

Contact Daly Middle East to discuss your project requirements.