Reading a tag, tracing a leak path and inspecting a coating call for different light. Start with the surface and the likely viewing position. A concentrated beam may help pick out a distant feature, while a broad beam can show the surrounding surface and where the inspector is placing their hands.
Trial a normal visual inspection setup
Check reach, reflected glare and shadows with the actual protective equipment and sample surface. An angled light or headlamp can make the job easier when both hands are occupied. Confirm the beam and runtime in the mode the user will actually select. Verify the exact equipment marking, approved batteries and instructions for charging and accessories.
Treat ultraviolet inspection as a separate method
Where a procedure calls for UV-A, specify the source characteristics, measurement conditions and exposure controls required by that procedure. A decorative UV light or a germicidal UV-C device serves a different purpose. UV can injure eyes and skin, so use the process controls and protection specified by the responsible inspection team.
For visible-light examples see Daly’s Nightstick range and intrinsically safe headlamp listing. For UV exposure context see the FDA overview of ultraviolet radiation.
Contact Daly Middle East to discuss your project requirements.